Page 20
Direct Model Select
Digital Trim Memory
Dual Rate
Throttle Cut
U
S
S
AVED
M
ODEL
P
ROGRAMMING
D
ATA
S
AVES
M
ODEL
-S
T
RIM
V
ALUES FOR EACH OF THE
P
RIMARY
F
LIGHT
C
ONTROLS
U
R
C
ONTROL
T
A
ILERON
, E
LEVATOR
,
AND
R
UDDER
C
HANNELS
U
S
HUT
D
OWN
Y
OUR
E
NGINE
R
T
HROTTLE
C
HANNEL
C
ONTROL
T
HROW
SED TO
ELECT
PECIFIC
SED TO
SED TO
EDUCE THE
HROW OF THE
BY
EDUCING
This section details the different Control Functions that the SD-5G transmitter features. These Control Functions are different
from the programmable Menu Functions.
The SD-5G transmitter can store Programming Data for up to 3 different models - Model 1, Model 2, and Model 3. The Direct
Model Select function allows you to select which of the three models you would like to use.
Prior to setting up a new model, make sure that you select a Model Number that doesn't include one of your current model's
Programming Data. This will prevent you from accidentally overwriting the Programming Data of a current model.
IMPORTANT
To reset the Programming Data for a model, each menu option must be reset individually by navigating
each model will automatically be loaded when the transmitter is turned ON.
Each time a trim switch is pressed, the trim moves in 5% increments and a single audible tone sounds. When the trim reaches
Zero, a double audible tone sounds. This allows you to know when the trim is centered without needing to look down at the
Using the Trim Switches
1) When you press a trim switch, the Trim value and channel will be displayed
in the Programming Window. Push the trim switches forward (or right)
to increase Trim in one direction and pull the trim switches back (or left) to
increase Trim in the opposite direction. The current amount of Trim for that
particular channel is displayed in the Programming Window.
We suggest always keeping the throttle Trim value at 0 or at a value that allows a minimum reliable idle. The transmitter
features a Throttle Cut function which is used to shut down your engine. This is easier, faster, and safer than using the
throttle trim switch to shut down your engine, and prevents you from having to continuously readjust your engine's idle speed.
CONTROL FUNCTION CONTROL FUNCTION DESCRIPTION
The following Control Functions are featured:
Using the Direct Model Select Function
1) Turn the transmitter OFF.
2)
then turn the transmitter ON. The Model Name (either MODEL 1, MODEL 2,
or MODEL 3) will be displayed at the bottom of the Programming Window.
INC+/M1 selects Model 1, DEC-/M2 selects Model 2, and CH/M3 selects Model 3.
CONTROL FUNCTIONS
DIRECT MODEL SELECT
DIGITAL TRIM MEMORY
transmitter during flight.
Press and HOLD the programmig key of the model you wish to setup or fly,
Before flying, verify that the Model Name displayed in the Programming Window is the actual model that you'll be flying.
to the specific menu option, for example, EPA TH H, and pressing the INC/+M1 and DEC-/M2 keys at the same time. We
suggest doing this first if you're programming a new model over an existing model.
The SD-5G transmitter features Digital Trim Memory. Any amount of control surface trim that you set during flight using the
trim switches is automatically stored in memory for that specific channel and for that specific model. The Digital Trim values for
