Sanwa RD700, Инструкция по эксплуатации

Страница: 13 / 34

DRAWING No. RD700/701 06-1404 2040 6010
5-2-1 Voltage measurements
DC/ACV: Maximum rating input value 1000 VDC/AC
1) Applications
DCV: Voltage of the battery and DC circuit are measured.
ACV: Sine wave AC voltage such as lighting voltage is
measured.
2) Measuring ranges
DCV & ACV: 5 ranges from 400.0 mV to 1000 V
3) Measurement procedure
Connect the plug of black test lead to COM terminal and
plug of red test lead to V terminal.
Set the function switch to ' V ' or ' V '.
Apply the red and black test pins to the circuit to measure.
For measurement of DCV, apply the black test pin to the
negative potential side of the circuit to measure and the
red test pin to the positive potential side.
For measurement of ACV, apply the red and black test
pins to the circuit to measure.
The reading of Voltage is shown in the display.
After measurement, release the red and black test pins from
the object measured.
Note:
1) AC 400.0 mV range selection is the manual operation
switching by RANGE button.
2) It may fluctuate the value when the input terminal is opened,
because the input impedance of DC/AC 400.0 mV range is
1000 M
Ω
. But this is not malfunction and there is not
hindrance in measurement.
3) The accuracy is not specified from 0 to AC 10 mV (RD701:
0~AC 40 mV) when the function was set up to the ACmV
range.
4) The reading does not become 0 when the input terminal was
shorted. But this does not bring about the influence to
measurement.
— 10 —
5-2 Voltage measurement / Frequency measurement
1. Never apply an input signal exceeding the maximum
rating input value.
2. Be sure to disconnect the test pins from the circuit when
changing the function.
3. Always keep your fingers behind the finger guards on the
probe when making measurements.
WARNING