Sanwa DMM PC520M, Инструкция по эксплуатации

Страница: 16 / 45

D-1034-141 SANWA PC520M(E)
— 13 —
Crest Factor
The crest factor (CF) is expressed by a value obtained by dividing the
peak value of the signal by its RMS value. Most common waveforms such
as sine wave and triangular wave have a relatively low crest factor. The
voltages and crest factors of typical waveforms are shown in the table.
Please note the measurement should be taken at the crest factor below 3.
NMRR (Normal Mode Rejection Ratio)
NMRR is the DMM's ability to reject unwanted AC noise effect,
which causes inaccurate DC measurements. NMRR is typically
specified in terms of dB (decibel). This series has a NMRR
specification of >60dB at 50 and 60Hz, which means a good
ability to reject the effect of AC noise in DC measurements.
CMRR (Common Mode Rejection Ratio)
Common mode voltage is voltage present on both the COM and
VOLTAGE input terminals of a DMM, with respect to ground.
CMRR is the DMM's ability to reject common mode voltage effect,
which causes digit rattle or offset in voltage measurements. This
series has a CMRR specifications of >60dB at DC to 60Hz in
ACV function; and >120dB at DC, 50 and 60Hz in DCV function.
2
π
――
τ
2
π
――
τ
τ
2
π
―― •Vp
Sine Wave
Square Wave
Triangular Wave
Puls
Input Waveform
Peak
Vp
RMS
Vrms
Average
Vavg
CF
Vp/Vrms
Form Factor
Vrms/Vavg
Vp Vp Vp 1 1
Vp
0
π
2
π
Vp
0
π
2
π
Vp
0
π
2
π
Vp
0
τ
2
π
=1.414Vrms =0.707Vp =0.637Vp =1.414 =1.111
=1.732Vrms =0.577Vp =0.5Vp =1.732 =1.155
Vrms ･ 2
Vp
――
2
2Vp
――
π
2
π
――
2 2
Vrms ･ 3
Vp
――
3
Vp
――
2
3
2
――
3
Vp
τ
2
π
―― •Vp
PC520M̲英 06.4.28 3:30 PM ページ 13