Sanwa DCM2000DR, Инструкция по эксплуатации

Страница: 4 / 34

— 2 —
7PMUBHFT PWFS %$ 7 PS "$ 7SNT 7 QFBL BSF
hazardous to human body. Take care so as not to touch them.
3. Never input signals exceeding the maximum rated input
value (see 1-3).
4. Never use the meter for measuring voltages of lines
DPOOFDUFEUPFRVJQNFOU FHNPUPSTUIBUHFOFSBUFTJOEVDFE
or surge voltage since it may exceed the maximum allowable
overload input.
0 5. Never use the meter if the meter or test leads are damaged
or broken.
0 6. Never use the meter with the case or battery lid removed.
0
%VSJOHNFBTVSFNFOUEPOPUIPMEUIFJOTUSVNFOUCZBQPTJUJPO
on the test pin side of the barrier on the test probe or by a
position beyond the barrier on the clamp sensor.
0 8. Do not switch the function in the middle of measurement.
0
#FGPSFQFSGPSNJOHNFBTVSFNFOUNBLFTVSFUIBUUIFGVODUJPO
and range are properly set.
10. Never use the meter when it is wet or with wet hands.
/FWFS BUUFNQU SFQBJS PS NPEJGJDBUJPO FYDFQU GPS CBUUFSZ
replacement.
12. Perform start-up inspection and inspect the meter at least
once a year.
13. This meter is for indoor use only.
14. Do not use the instrument in a method other than specified.
0UIFSXJTFUIFQSPUFDUJPOGVODUJPONBZCFTQPJMFE
5P BWPJE FMFDUSJD TIPDL BMXBZT CF TVSF UP EJTDIBSHF UIF
high voltage charged in the measured device after
measuring insulation resistance.
2. Do not apply the voltage and current inputs simultaneously.
0UIFSXJTFNBMGVODUJPOXJMMIJOEFSBDDVSBUFNFBTVSFNFOU
3. Do not apply a strong force or impact to the clamp sensor
section.
CAUTION