3
2
B
Remove filter
2 Operating the Quick Release Fastener
1 ECAIA nitrate cartridge
3 Installation and replacement
The
ECAIA nitrate cartridge
reduces the amount of nitrate in drinking water.
Please be aware that the
ECAIA nitrate cartridge
is a product that is to be
used for filtering cold drinking water (5 - 25° C). The filter’s performance may
vary depending on the quality of the drinking water.
A
Connect filter
1. Turn off the water supply to the
ECAIA ionizer S
(or other model). The drinking wa-
ter supply hose, which supplies the unit with water, must no longer be pressurized.
2. Cut the drinking supply hose at the point where you want to place the
ECAIA nitrate
cartridge
so that you have two hose pieces.
Note
: Please note that residual water could still leak from the drinking water
supply hose.
3. Remove the safety pins on both quick-release fasteners on the new
ECAIA nitrate
cartridge
. Then pull the protective caps out of the quick-release fastener openings.
4. Take one end of the drinking water supply hose connected to the T-piece or the re-
versible aerator. Connect the water supply hose to the quick-release fastener open-
ing of the
ECAIA nitrate cartridge
and fasten the safety pin.
Note
: Pay attention to the flow direction when connecting the
ECAIA ni-
trate cartridge
. The water must flow into the
ECAIA nitrate cartridge
at the
quick-release fastener of the screw-off cap.
The
ECAIA nitrate cartridge
has quick-release fasteners (1/4”). Below is a description of how
these quick-release fasteners work.
Always make sure that the drinking water supply hose
(1/4“) is not kinked or otherwise damaged at the point
where it is inserted into the quick-release fastener opening. If
this is the case, cut off the damaged piece.
1. Insert the drinking water supply hose (1/4“) at least 1 cm
deep into the quick-release fastener opening.
2. Fasten the safety pin.
3.1
First Installation
Installation
3. To release the hose from the quick-release fastener, the
drinking water supply hose (1/4“) must no longer be pres-
surized.
Remove the safety pin, push the locking ring all the way
back and then pull only the drinking water supply hose
(1/4“) out of the quick-release fastener opening.