Sanus XF228, Инструкция по эксплуатации

Страница: 9 / 40

6901-002115 <03>
9
2
Mount the Wall Plate
Solid concrete or concrete block
2-1
Mark the wall
2-2
Drill pilot holes
2-3
Insert anchors and lag bolts
13 mm
(1/2 in.)
10 mm
(3/8 in.)
Drill pilot holes as illustrated.
CAUTION:
Avoid potential injuries or property damage! :
Ù
Pilot holes MUST be drilled to a depth of 89 mm (3.5 in.) using a
10 mm (3/8 in.) diameter drill bit.
Ù
Never drill into the mortar between blocks.
Insert lag bolt anchors [25] . Then insert lag bolts [23] through the
washers [24] , wall plate [01] , and into the anchors.
CAUTION:
Improper use could reduce the holding power of the
lag bolt. To avoid potential injuries or property damage:
Ù
Be sure the anchors [25] seat fl ush with the concrete surface.
Ù
Tighten the lag bolts [23]
only until the washers [24]
are pulled fi rmly against
the wall plate [01] .
Ù
DO NOT over-tighten the lag
bolts [23] .
For assistance in determining wall plate location, see Height Finder at
sanus.com.
Level the wall plate [01] and mark the hole locations.
CAUTION:
Avoid potential injuries or property damage!
Ù
Mount the wall plate [01] directly onto the concrete surface.
Ù
Minimum solid concrete thickness: 203 mm (8 in.)
Ù
Minimum concrete block size: 206 x 206 x 406 mm (8 x 8 x 16 in.)
Ù
For all concrete applications, the arm must remain centered in
the wall plate (step 3). Keep this in mind when selecting the wall
plate location.
Ù
Minimum horizontal space between fasteners: 406 mm(16 in.).
[01]
[25]
[01]
[23]
[24]
≥41 cm
(16 in.)
89 mm
(3.5 in.)