User manual
SNC-8322I / SNC-8322HO
_________________________________________________________________________________
- 63 -
Triggered action (multiple options):
The administrator can specify alarm actions that will be taken when tampering is detected.
Options are as follows:
Enable alarm output:
Activate this item and select “high” or “low” to enable the alarm relay output when
tampering is detected.
Record stream to SD card:
Select this item and the tampering alarm recording will be stored on the micro SD/
SDHC card when tampering is detected.
Pre-trigger buffer recording function allows users to check what happened to cause
the trigger. The pre-trigger buffer time range is from 1 to 9 seconds.
Select <Upload for … sec> to set the recording duration after tampering occurs. The
setting range is from 1 to 9999 seconds.
Select <Upload during the trigger active> to record the triggered video until the trigger
is off.
Note:
Please make sure that a micro SD/SDHC card is inserted into the camera in order to
make the recording work.
Also refer to chapter “2.3.9 Recording” for further details.
Send alarm message by FTP/e-mail:
The administrator can select whether to send an alarm message by FTP and/or
e-mail when tampering is detected.
Upload image by FTP:
Select this item and the administrator can assign a FTP site and configure various
parameters. When tampering is detected, event images will be uploaded to the
appointed FTP site.
<Pre-trigger buffer> function allows users to check what happened to cause the
trigger. The <Pre-trigger buffer> frame rate could be pre-determined.
<Post-trigger buffer> is for users to upload certain amount of images after tampering
is triggered.
Check the box <Continue image upload> to upload the triggered images during
certain time or keep uploading until the trigger is off. Select
<Upload for … sec> and
enter the duration in the field (1-99999). The alarm images are stored on the FTP site.
Select <Upload during the trigger active> to make the images keep being uploaded to
FTP until the alarm trigger is released. Set the image frequency as the upload frame
rate (1-15 frames).
Note:
Make sure the FTP configuration has been completed.
Also refer to chapter “2.3.4.2 FTP Server” for further details.