background image

Installation Instruction

 

Please read the instructions completely before beginning the installation.

Circ

 Collection

       

Model Number: 

3920CI

Flush both supply lines before installation, then shut off both supply lines.

Minimum hole size for the spout and handle trim is 1-1/4” and maximum of 1-1/2”

    - Remove the tee connector, spout mounting hardware and tee

    connector washer from the bottom of the spout assembly. Apply

a ring of silicon caulking around the center hole on the top of the sink.

Do not use plumbers' putty which can damage the finish of the faucet.

- From the top of the deck, insert the spout's threaded shank through

the center hole of the sink. Make sure the spout flange washer is

properly placed underneath of the flange and gently pressed against

the sink top.

1

Rev 

1

/20

20

The measurements shown are for reference only. Products and specifications shown are subject to change without notice.

www.santecfaucet.com   |   P: 310.542.0063   F: 310.542.5681    

SPOUT INSTALLATION

    - Slip the spout mounting hardware back onto the spout. First the

    notched rubber washer, then the notched metal washer and lastly

the brass lock nut. Hand tighten the lock nut.

- Tighten the lock nut. Make sure the 

spout does not move side ways

Adjust

 

it if necessary.

- Place the tee connector washer into the tee connector and thread

the tee connector onto the end of the spout shank. Tighten to seal.

- Align the spout and tighten the shank lock nut firmly.

2

Rubber washer

1/7

Notched rubber washer

Notched metal washer

Spout stabilizer

Brass lock nut

Tee connector

Tee connector washer

                  CIRC COLLECTION 

WIDESPREAD LAVATORY SET

    

Содержание CIRC 3920CI








Отзывы: