5
Test the push pop-up for smooth operation. to open push pop-
up simply push once. Push again to close it.
PUSH
POP-UP INSTALLATION
1
Remove th
e
drain
plug and gasket from
push pop-up assembly.
remove the washer
,
lock nu
t and un-thread bottom drain tube.
add silicon sealant/putty around the flange. Secure by adding
rubber washer, gasket, plastic washer and lock nut.
2
Insert
flange o
n
the drain
hole
up through bottom of lavatory.
3
Insert the threaded end of the assembly up from the under the sink
so that t
he
drain tube is
firmly attached
t
o
the drain
plug.
.
Make sure t
o add
plumber
tape before threading the drain tube
.
4
Make sure the
thread
of
drain flange
and
bottom
of the drain tube
are tighten.
If not
it may cause water leaks.
add tape or t
ighten the locknut from
under the sink.
The measurements shown are for reference only. Products and specifications shown are subject to change without notice.
www.santecfaucet.com | P: 310.542.0063 F: 310.542.5681
3/7
