6
Santa Fe Air Purifier Installation & Operation Instructions
Santa-Fe-Products.com
Touching the power button will turn on the air puriͤer. The unit default is Auto Mode and will
display “000” flashing and “
”. The air quality indicator on the screen will alternate between
green, yellow, orange and red. Fifteen seconds later, it will show real-time air quality data and
light up with the corresponding color to the table below. After that, air puriͤer will adjust the
speed according to the air quality automatically.
Speed:
Pressing the “Speed” button will remove the air puriͤer from Auto Mode. This button
allows the user to cycle through fan speeds: low speed, medium speed and
high speed.
The fan speed cannot be changed during Auto or Sleep modes.
Timer:
Touching the timer button will cause the display to flash “--H” and “TIMER”. Press and
hold the button to set the timer from 1-12 hours. After choosing the desired time, wait two
seconds for the display to stop flashing. After 3 seconds the display will show PM2.5 data,
indicating setting is done. It calculates by counting down every hour. When the time is up, the
air puriͤer shuts down.
Touch the button till icon “--H” or long press the button for 2 seconds to cancel timer setting.
UV:
Touching the “UV” button turns on the UV sterilization function and lights up the UV
symbol. To turn off the UV function press the “UV” button again, the UV symbol should go
dark.
Sleep:
Touching the “Sleep” button will put the air puriͤer into Sleep Mode. Sleep Mode uses
the lowest possible fan speed to create a quite environment.
The display and all buttons will turn off leaving only the “Sleep” button lit up at one-third
brightness. Touching the sleep button again will return the unit Auto Mode.
F E A T URE S A ND OP E RA T ION
Auto Mode Chart
Color
Air Quality
PM2.5 Data
Fan Speed
Red
Bad
>151
High
Orange
Moderate
150~101
Medium
Yellow
Good
100~51
Low
Green
Very Good
<51
Lower
Содержание KF-P32
Страница 11: ...Santa Fe Products com...
