-
9
-
Battery installation
1
3
2
1.
Open the battery cover
2.
Insert the battery
(
notice the polarity
○
＋
/○
－
)
3.
Close the battery cover
4.
Battery specification: DC 3V (CR2430)
※
Notice:
About the battery
The battery provided with the product is prepared for your initial use.
For the battery replacement, please use a battery with the same specifications.
If the remote control is not going to be used for a long time, please take the battery out.
About the remote control:
Please do not install the socket at a location that may be exposed to direct sunlight.
If the Remote Control activates other electronic appliances, please contact the distributor.
Caution:
15.21
You are cautioned that changes or modifications not expressly approved by the part responsible for compliance could void the user’s
authority to operate the equipment.
15.105(b)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1)
this device may not cause interference and
2)
this device must accept any interference, including interference that may cause undesired operation of the device.
