SANLI GTS26, Руководство оператора

Страница: 14 / 30

14 / Operator’s Manual Sanli GTS26
• Press on the priming pump until
the fuel becomes visible (2 to 3
times).
• Put the Start/Stop switch into the
Start position (fig. 5).
• Put the choke in the start position
towards the top.
• Pull quickly and firmly on the starter recoil starter, then follow it
back down to its initial position.
• If the engine does not start after the first pull, repeat until it
does.
• After the engine has been running for 15 to 30 seconds, put
the choker back in its initial position towards the bottom (run).
• Holding the safety trigger down in
the palm of your right hand, press
on the throttle lever with your
index finger. Progressively action
the throttle lever to increase the
rotation speed of the engine and
engage the nylon spool (fig. 6).
Starting when the motor is hot
NOTE: When starting the machine while hot or after the first time it is
started, you do not need to use the choke. To start the machine
when hot, repeat the same steps as for when starting from cold, but
do not use the choke
WARNING: If the motor does not start after four attempts, continue
as you would if the engine was cold.
3.22 Stopping the brush cutter
• Release the throttle lever.
• Put the Start/Stop switch into the STOP position.
• The nylon line will stop completely after a brief moment.
Safety trigger
Throttle lever