SANLI GT 26, Руководство оператора

Страница: 12 / 28

12 / Opera
tor’s Manual Sanli GT26
3.2 Using the petrol trimmer
Before use, always check that the safety elements are present and
working properly.
Also check that the cutting and fixing elements are in good working order.
If necessary, replace or repair faulty components. Only use original parts
or those approved by SANLI UK.
Do not throttle unnecessarily and check that the nylon spool stops when
the throttle control is released
3.21 Starting the trimmer
The starting method differs depending on whether the motor is hot or cold.
Starting when the motor is cold
Place the tool on an even surface, hold the handle with your left hand,
and hold the rear handle firmly with your right knee.
Press on the priming pump until the fuel
becomes visible (2 to 3 times).
Put the Start/Stop switch into the Start
position (fig. 5).
Put the choke in the start position
towards the top.
Pull quickly and firmly on the starter
recoil starter, then follow it back down to its initial position.
If the engine does not start after the first pull, repeat until it does.
After the engine has been running for 15 to 30 seconds, put the choker
back in its initial position towards the bottom
(run).
Holding the safety trigger down in the
palm of your right hand, press on the
throttle lever with your index finger.
Progressively action the throttle lever to
increase the rotation speed of the
engine and engage the nylon spool (fig.
6).
Safety trigger
Throttle lever