Sanli Brushcutter User Guide
11
Starting your brushcutter.
Before operating your brushcutter, mix 25 parts of regular unleaded petrol to 1 part
2-stroke oil (25:1). Do not overfi ll the tank as this can risk fuel spilling on hot parts when
in use.
Slide the ignition switch forward away
from the STOP position
(Figure 18).
Press primer bulb three or four times
until a fl ow of fuel is visible inside the
fuel line
(Figure 19)
.
Set choke lever into closed position
if starting from cold
(Figure 20).
Pull the starter cord until the
brushcutter starts (or sounds like it
wants to start) then return choke to
open position
.
After it starts, allow the engine to warm
up for at least 20 to 30 seconds.
For warm restarts, do not prime, just
pull the cord and it will start after one or
more pulls.
To stop the engine, simply move the
ignition switch back to the
STOP
position
(Figure 21).
Figure 18.
Figure 19.
Figure 20.
Figure 21.
