Sanitas SBM 22, Инструкция по эксплуатации

Страница: 28 / 122

28 29
• Insert the mains part into the connection provided for
this purpose on the right-hand side of the blood pressure
monitor.
• Then insert the mains plug of the mains part into the
mains socket.
• After using the blood pressure monitor, unplug the mains
part from the mains socket first and then disconnect it
from the blood pressure monitor. As soon as you unplug
the mains part, the blood pressure monitor loses the date
and time setting but the saved measured values are re-
tained.
Adjusting the settings
Make sure that the device’s settings have been set correctly
so you can make full use of all its functions. Otherwise you
will not be able to save your measured values with the date
and time and access them later.
There are two different ways to access the settings menu:
• Before initial use and after each time you replace the
battery:
When inserting batteries into the device, you will be taken
to the relevant menu automatically.
• If the batteries have already been inserted:
Press and hold the settings button
SET
on the device
when switched off for approx. 5 seconds.
Set these settings in the order shown below:
Hour
format
➔
Date
➔
Time
➔
Alarm
➔
User
Press
SET
to confirm your selection each time.
Time format
Time format flashes:
• Press +/- to select the time format
Date
The year flashes:
• Press +/- to select the year
The month flashes:
• Press +/- to select the month
The day flashes:
• Press +/- to select the day
If the time format is set to the 12-hour format, the
order in which the day and month are displayed is
reversed.
Time
The hour flashes:
• Press +/- to select the hour
The minutes flash:
• Press +/- to select the minutes
Alarm
You can set 2 different alarm times to remind yourself to take
the measurement. To set the alarm, proceed as follows:
• Press and hold the function buttons - and + simultaneously
for 5 seconds.
• Alarm
1
is shown in the display, “on” or “off” flashes
at the same time. With the function buttons +/- , choose
whether Alarm
1
should be activated (“on” flashes) or