Sanitas SBC 53, Инструкция по эксплуатации

Страница: 34 / 96

34
Step 4: SBC 53
data transfer immediately
following measurements.
• If Bluetooth
®
data trans-
fer has been activated,
data is by transferred after
having confirmed the user
memory by pressing the
pressing the START/STOP
button .
Step 4: SBC 53
Data transfer at a later point:
• Go to memory mode
(chapter 7). Select the
desired user memory. The
Bluetooth
®
transfer starts
automatically.
The HealthCoach app must be active to allow data transfer.
If your smartphone has a protective cover, remove this to en-
sure that there is no interference during the transfer. Begin the
data transfer in the HealthCoach app.
8. Cleaning and storing the unit
• Clean the device and cuff carefully using a slightly damp
cloth only.
• Do not use any cleaning agents or solvents.
• Under no circumstances should you hold the unit under wa-
ter, as this can cause liquid to enter and damage the unit.
• If you store the device, no heavy objects should be placed on
top of it. The cuff line should not be bent sharply.
In such cases, repeat the measurement and/or data transfer.
Ensure that the cuff line is correctly attached and that you do
not move or speak during the measurement.
9. Error messages/troubleshooting
In the event of errors, the error message _ appears on the
display.
Error messages may appear if:
• it was not possible to record the pulse:
1
;
• you move or speak during the measurement:
2
;
• the cuff is fastened too tightly or loosely:
3
;
• errors occur during the measurement:
4
;
• the pump pressure is higher than 300 mmHg:
5
;
• the batteries are almost empty :
6
;
• the data could not be sent via Bluetooth
®
.
The word mark Bluetooth
®
and accompanying logo are reg-
istered trademarks of Bluetooth
®
SIG, Inc. Any and all use of
these marks by Hans Dinslage GmbH is done so under licence.
Other trademarks and trade names are the property of the
relevant holder.