Step 2
Attach Lower Cord Hook
Make sure cord hook is pointing
downwards. Press the power cord
into the groove on the cord hook
pulling any slack toward the base of
the cleaner. On the cord hook, find
the curved tab and place in slot on
lower handle section, keep cord taut
while pressing the cord hook to the
left until it snaps into slot on opposite
side of handle. The hook should
point downward on the same side
that the cord exits the hood.
Step 3
Attach Outer Bag
Impor tant: To provide a good
gasket seal, the bag coupling
must seat firmly against the motor
base.
Hold outer bag with zipper away from
the handle. Line up screw holes.
Start the bag screws by hand, then
tighten with a screwdriver.
Loop the bag spring onto the bag
support hook located at the back of
the upper handle section.
Step 4
Store Electrical Cord
6
2
3
3
4
4
2
The cleaner has two convenient cord storage
hooks attached to the handle. However, some
models feature a quick release cord hook on the
upper handle. A downward twist of the cord hook
frees the cord for quick removal. With either style,
wind the cord around the hooks for storage.
Fasten the plug to the cord to prevent unwinding.
