//
MIXER INSTALLATION
ENGLISH
FRANÇAIS
step
1º
1 –
Shut off the water supply.
Cut an adequate opening in the wall for the dimensions of
the Tubular box, the cables sleeve, the rigid pipes and the
base (at the place where you want to install the spout). Keep
a distance of more than
300
mm between the bottom of the
washbasin and the mixer.
2 –
Insert the box through the wall. Connect the water
supply pipe to the nipple at the bottom of the box.
3 –
Prepare the support bar for the base by assemble the
angle supports with the 4 provided screws. Then mount the
base through the wall opening using the 2 screws and
anchors provided.
(see picture)
Important:
The base should be installed so that the
outside surface of the finished wall falls between the
minimum
and maximum lines marked at protective plastic cover.
4 –
Assemble the rigid pipes from the nipple at the box to the
inlets at the base.
5 –
Insert the cables sleeve inside the box through the hole
at the top of the box. If the cables sleeve is too long at
the specific location, you can shorten it as needed. Make sure
you will not damage the cables inside the sleeve while you
installing the mixer
46//
47
cut it.