7. Connection of side-inlets (shower and washbasin)
6. Connection to a WC
The fl exible sleeve is designed to fi t onto the 100mm WC pan spigot.
Grease the pan spigot with silicon lubricant or liquid soap.
Align the fl exible sleeve with the pan spigot.
Pull the fl exible sleeve over the pan spigot using the two ears projecting from the sleeve.
Warning: If the height of the WC can be adjusted, give a 3% minimum fall to the discharge pipe.
1
2
To make the connection to the side inlets, use connector (A). Secure it with plastic clips (B) and (C).
• Cap off unused inlets with plugs (D) (pre-grease the joint before fi ting).
Warning: When fi tting a shower, ensure that the underside of the tray is at least 12cm above fl oor level.
8. Connection of a washbasin
SILIC
ONE
The washbasin can be connected in two ways.
To one of the side inlets.
To the inlet on the lid (the premarked opening has to be cut out)
• Use a suitable cutter to make the opening in the lid.
• There is a ridge where the hole has been partially pre-cut. Cut the
hole with care, and de-burr it, to avoid leaks when adapter is fi tted.
• Insert the adapter (E) into the lid.
• Slide the washbasin waste pipe into the adapter (it will accept 32mm
or 40mm pipe).
ø 100
100mm
3%
min
180mm
ø 40
DN 40
ø 1½
CLOSED
DN 32/40
A
C
B
D
E
D
