11. In case a service is needed
Allow for a drain-off point at the bottom of the rising
discharge pipe. Ensure that the unit is easily accessible
for possible maintenance.
13. Standard
Sanicom conforms to Standard EN 12050-2. Lifting station for waste products not containing faecal matter.
SANICOM®
Société Française d’Assainissement
EN 12050-2/03
FF03-P95
220 - 240 V - 50 Hz - 750 W - IP44
12. Electrical connection
14. Alarm
There is the option of connecting an alarm (light, bell)
on to the electronic circuit board (2 terminals fed
with 220V). If the motor is run continuously (more than
5 minutes), the contact will be made. This enables the
user to carry out a check if he wishes.
Connection of the alarm
Two 6.35 push on connection points are available on the
electronic circuit board (arrowed) for creating an alarm
circuit. (These connectors have a 220V, 0.5A maximum
current passing through them). To access them after
turning the power off, remove the cover then unscrew
and unclip the upper casing of the electronic box, to
expose the electronic circuit board. On this card use the
point marked
E.V.
and the unused neutral connection
point marked
N.
Use a round 2 x 0.75mm 2 wire, which
must pass across the lid of the upper casing, through the
cable gland, before being connected to the chosen alarm
system.
The electrical installation should be carried out by a qualified person.
All wiring must conform to BS7671, 1992 requirements for electrical installations. The Sanicom requires a
220/240V single phase AC 50 Hz supply (UK specification). Do not connect the Sanicom to a conventional plug and
socket. It must be wired into a fused, unswitched, fixed wiring connector fitted with a 5 amp fuse. The Sanicom
has an earth wire. The wires in the mains lead are coloured in accordance with the following code:
Brown – Live Blue – Neutral Green/Yellow – Earth
Warning:
Ensure the electricity is turned OFF at the main switchboard before wiring to connector.
All work on cable, pressure chamber and motor should only be carried out by a qualified Saniflo servicing agent,
as special tools are required.
UK – 230/240V 50Hz.
The unit should be installed so it is easily accessible/removable for possible maintenance.
The unit should not be exposed to splashing in normal use.
CANADA
USA
EUR
CH
GB
Содержание Sanicom FF03-P95
Страница 7: ...19 Parts ...
