Sangean HDR-18, Руководство пользователя

Страница: 8 / 21

7
Power your radio
The AC power adaptor required for this unit should be 12 volts DC at
1.5A center pin positive.
Insert the adaptor plug into the DC socket on the rear of the radio. Plug
the adaptor into a standard AC outlet.
IMPORTANT:
The AC adaptor is used as the means of connecting the radio to
the power supply. The AC Adapter used for the radio must remain
accessible during normal use in order to disconnect the radio from the
power supply completely, the AC Adaptor should be removed from the
power supply outlet completely.
Antenna setup for FM reception
This radio comes with a built-in AM/FM antenna and has external
antenna connections.
To use the FM internal antenna, make sure to switch FM external/
internal antenna switch in the back of your radio to internal antenna
position (i.e. INTERNAL). As for external antennas, there are two types
of antennas that can be used to improve FM reception.
You can connect the supplied FM antenna to the F-type antenna
terminal and adjust the telescopic aerial for best reception.
You can also connect a 75 ohm coaxial cable of an outdoor antenna to
the terminal.
Make sure to switch external/internal antenna switch to external position
after connecting an external antenna.
Note:
In some of the European countries, you may have to use an adaptor
plug to connect with the outdoor/rooftop antenna in case your antenna
has a different type of plug.
Antenna setup for AM reception
This radio comes with a built-in AM Ferrite antenna which should be
enough for normal listening. To improve the AM reception, you may
connect an external AM antenna (not supplied) to the AM external
antenna terminal on the back of the unit.
Important:
If you choose to use an AM loop antenna ensure it’s located at least 20”
away from the receiver to avoid possible interference.
Setting the clock
Clock setting can be done when the receiver is on or in Standby Mode
(power off).
Setting the clock manually
1. Repeatedly press the Menu button until ‘Clock Update’ is shown on
the display.
2. Rotate the Tuning control knob to select ‘Manual’ and press the Tu-
ning control knob to enter the clock time setting. The hour digit will be
highlighted on the display.
3. Rotate the Tuning control knob to set the desired hour. Then press
the Tuning control knob to confirm the setting. The minute digit will be
highlighted on the display.
4. Rotate the Tuning control knob to set the desired minute and press
the Tuning control knob to confirm the setting. Now the month digit
will be highlighted on the display.
5. Follow the steps above to set the month/day/year setting. When the
clock time setting is completed, your radio will exit the menu.