KBox E-410-APL - User Guide, Rev. 1.0
// 27
5.1.
Opening and Closing the KBox E-410-APL
Before opening the KBox E-410-APL, the system must be switched off and disconnected
from the main power supply. Also, disconnect all peripheral devices from the KBox E-
410-APL. Before you begin, ensure that you have a clean, flat and ESD-safe surface to
work on.
For opening and closing the KBox E-410-APL, please perform the following steps:
1.
Close all applications. Shut down the system properly and disconnect the connection to the main power source.
Disconnect all peripherals.
2.
The KBox E-410-APL should lay on a flat, clean surface with the access cover facing upwards.
3.
Loosen and remove the Phillips screws (two located on the bottom side, three on front and rear side each), that
secure the access cover to the chassis. Retain the screws for later use.
Figure 5: Descrewing the access cover of the KBox E-410-APL