GB-1
GB-2
GB-3
UNPACKING
Remove all packaging from the kettle. Retain the packaging. If you
dispose of it please do so according to local regulations.
The following items are included:
• The kettle
• Instruction Manual
(P.N.: S17AJK10-001)
If items are missing, or damaged please contact Partmaster (UK only).
Tel: 0870 6001 338 for assistance.
FIRST TIME USE
Clean your kettle by boiling a full kettle of water twice and then
discarding the water.
KEEPING THE MAINS CABLE TIDY
Extend the mains cable in the kettle stand to the required length. Locate
the mains cable in one of the slots in the stand. For safety it is
recommended that the length of the exposed mains cable is kept as
short as possible. Place the kettle stand on a firm level surface and plug
in the mains plug to the mains socket.
PRODUCT OVERVIEW
FILLING THE KETTLE
Press the open button to open the lid and fill the kettle with the required
amount of water.
Do not exceed the maximum fill level
(Max 1.7L) as indicated inside the
kettle and not less than the minimum
fill level (Min 0.75L).
CHECKING THE WATER TEMPERATURE
The kettle is equipped with a thermometer.
This allows you to check on the
temperature of the water being boiled in
the kettle. You may stop the boiling process
halfway when the water has reached your
desired temperature. You may also re-boil
the water if the boiled water has cooled
down.
This kettle must only be used with the stand provided.
SWITCHING ON
Place the kettle on the stand and press the power switch to the ON
position (indicated by the symbol ‘I’).
The indicator on the side of the kettle will illuminate to indicate that the
kettle is operating.
If there is insufficient water in the kettle, the automatic safety
cut-out will operate. If this happens, allow the kettle to cool for ten
minutes before refilling with cold water and re-boiling.
CLEANING THE KETTLE
The kettle exterior should be cleaned with a soft damp cloth. Do not use
abrasive cleaners or scouring pads which may damage the finish of the
kettle.
Never immerse the kettle or kettle stand in water and always keep the
electrical contacts dry. Disconnect from the mains before cleaning the
kettle stand.
Do not insert any foreign objects or allow any liquid to spill into the
Power Connector Hole.
DESCALING THE KETTLE
Depending on the hardness of the water
in your area, limescale may be
deposited on the heating element and
the inside of the kettle. This normal
build-up is not harmful to health but an
excessive amount of scale may affect
the performance of the kettle.
To descale, fill the kettle with distilled
water up to three-quarters of the Max
level and bring the water to boil. After
the kettle has switched off, add a
descaling solution following the
manufacturers instructions. Never
attempt to descale the kettle by
chipping or scraping with a sharp
implement.
Never open the lid while the water is
boiling. The steam coming out from the
kettle is very hot.
Ensure that the switch is not obstructed
and the lid is firmly closed. The kettle will
not turn off if the switch is obstructed or if
the lid is open.
WHEN THE WATER HAS BOILED
The kettle will automatically switch off (indicated by the symbol ‘0’ ).
After removing the kettle, there may be some water on the surface
of the stand. This is condensation from the steam that causes the
kettle to automatically switch off after boiling. This is normal and
should not be a cause for alarm.
Power Connector Hole
Thermometer
Kettle Stand
Spout
Open Button
Lid
Water Fill
Level
Handle
Power
Switch
20°
40°
80°
60°
If the kettle is overfilled, boiling
water may be ejected from the
spout and cause scalding.
