S&S Precision LIFTR Series, Руководство пользователя, Страница: 23 / 23

1.) Lay out the Rebreather attachment
straps
2.) Weave PlateFrame shoulder
straps through LiftR-40.
11.) Repeat steps 7-10 on theopposite
cummerbund.
4.) Once shoulder strap is through
Tri-Glide, ensure Velcro is securely
fastened.
READ BEFORE USE
Rebreather Attachment System
5.) Place female release buckle of the
Rebreather shoulder attachment and
PlateFrame shoulder strap through
LiftR-40 retainment strap.
3.) Weave rear shoulder strap through
Rebreather Tri-Glide Shoulder
Attachment.
9.) Once the strap is woven down to the
bottom, tuck the Tenacious Tab back into
the Cummerbund Attachment System.
7.) Align Cummerbund Attachment
System on the inside of the
cummerbund. NOTE placement.
8.) The retention strap then gets woven
over the top of the cummerbund, then
into the first strap of the Cummerbund
Attachment System.
10.) When completed, the Cummerbund
Attachment System should look like
picture.
18-19.) Attach the LiftR-40 side release buckle around the entire cummerbund
assembly. Ensure the LiftR-40 lays next to the Rebreather system and inflation of the
LiftR-40 is not obstructed .
17.) Then, attach the left and
right Cummerbund Straps to the
Cummerbund Adjustment System.
16.) Once the PlateFrame is on, attach
the Adjustment Straps to the top left and
right of the Rebreather system.
15.) Put on the PlateFrame.
20.) Once everything is connected,
adjust straps accordingly.
6.) NOTE: Rebreather shoulder
attachment and LiftR configuration.
12.) Remove pre-existing carrying
straps from top and bottom of the
Rebreather system.
13.) Weave Adjustment Straps through
the existing carrying slots in the
Rebreather in all four locations.
14.) Once through the Rebreather,
weave strap through Tri-Glide, then back
through to lock it in place. Repeat this
step in other pre-existing locations.