S&P TL-40, Руководство по установке и эксплуатации

Страница: 15 / 36

15
4. Use and maintenance
 Select the power with power selector
O
Stop
Fan (cold air)
I
Hot air heater (1.000W)
II
Very hot air heater (1.800W)
 Turn the thermostat control until it is at the maximum position.
Min. Max.
 Once the room has reached the desired temperature, slowly move the control until
there is a soft “click” and the device is disconnected. From this time the heater
turns on and off automatically, keeping the pre-selected comfort temperature.
 Anti frost device thermostat .
This device is especially useful in places where low temperatures are reached and
there is a risk of water freezing in internal water pipes. The heater will
automatically maintain the temperature of the room at about +5ºC when left on this
setting.
 IMPORTANT: The LED will illuminate only if the heater stops for overheating, whether
due to a malfunction of the same or that the heating is being used inappropriately.
5.
Maintenance
 Before carrying out any maintenance work, make sure that the device has been
disconnected from the mains and let the heater cool down for a few minutes.
 Periodically, to prevent an accumulation of dust, clean the inlet air filter (Fig.1-5). Acting
on the same tab, you can easily remove the filter. You can use a damp cloth with water
or a vacuum cleaner. Never use petrol or aggressive and /or abrasive dissolvents to
clean the device.

To clean the heater body, use a damp cloth with water and never use petrol or
aggressive and/or abrassive dissolvents to clean the device.
 Do not immerse the device or spray with water.
 If the appliance is not to be used for any length of time, we recommend returning it to its
original package and storing it in a dry, dust-free place.