S&P TD - ECOWATT TD-160/100, Инструкция по эксплуатации

Страница: 12 / 56

Instructions Manual
ENGLISH
Thank you for placing your confidence in S&P by buying this product. It has been
manufactured following current technical safety regulations and in compliance with EC
standard.
Please read this instructions booklet carefully before installing or starting up the product.
It contains important information on personal and user safety measures to be followed
while installing, using and carrying out maintenance work on the equipment. Once the
product has been installed, please hand in this booklet to the end user.
Check that the apparatus is in perfect condition while unpacking. Any fault or damage
caused in origin is covered by the S&P guarantee. Please make sure that the apparatus
coincides with the product you have ordered and that the details on the instructions
plate fulfil your necessities.
Transport and manipulation.
-
The packaging used for this apparatus has been designed to support normal
transporting conditions. The apparatus must always be transported in its original
packaging as not doing so could deform or damage the product.
-
The product should be stored in a dry place in its original packaging, protected from
dust and dirt until it is installed in its final location. Do not accept delivery if the
apparatus is not in its original packaging or shows clear signs of having been
manipulated in any way.
-
Do not place heavy weights on the packed product and avoid knocking or dropping it.
Important information for the safety of installers and users.
-
Installation must only be carried out by qualified persons.
-
Make sure that the installation complies with each country’s current mechanical and
electrical norms.
-
Once ready to use, the apparatus must fulfil the following standards:
Standard for Low Pressure Instalments 73/23 CEE.
Standard for Electromagnetic Compatibility 89/336 CEE.
-
Ventilators, or apparatus that include them, have been designed to move the air in
the area stipulated on their characteristics plate.
-
This apparatus must not be used in explosive or corrosive atmospheres.
-
If a ventilator is going to be installed to extract air from premises where a boiler or
other combustion apparatus are installed, make sure that the building has sufficient
air intakes to assure adequate combustion. The extractor outlet must not be
connected to a duct used to exhaust smoke or fumes from any appliance that uses
gas or any other type of fuel.
-
This appliance is not intended for use by young children or infirm persons unless
they have been adequately supervised by a responsible person to ensure that they
can use the appliance safely. Young children should be supervised to ensure that
they do not play with the appliance
Safety during installation.
-
Make sure there are no loose elements near the ventilator, as they could run the risk
of being sucked up by it. If it is going to be installed in a duct, check that it is clean of
any element that could be sucked up by the ventilator.
-
When installing an apparatus, make sure that all the fittings are in place and that the
structure which supports it is resistant enough to bear its weight at full functioning power.
-
Before manipulating the apparatus, make sure the mains supply is disconnected,
even if the machine is switched off.