S&P PM-1005, Инструкция по эксплуатации

Страница: 6 / 10

ENGLISH
15
4.1. The appliances have double electrical insulation , so they do not require ground con-
nection. The power cord has three connection wires, connect them as indicated in
Figure 5. The Brown – Blue wires are connected to the L – N of the electrical installation.
The black wire is used when we want to control several Wall Heaters by means of a Pilot
wire programmer (Important for France). If you don’t have a Pilot wire programmer,
leave the wire correctly insulated in the same plug without connecting it.
5. INSTRUCTIONS FOR USE
CAUTION: Before proceeding with the device’s instructions of use, read all the Safety War-
nings in the relevant section of this manual carefully.
5.1. ON / OFF SWITCH
Press the main switch located on the side of the appliance (ON / OFF) to turn the appliance
on / off.
NOTE: If the appliance is not going to be used for a long period of time (summer), we recom-
mend disconnecting it using this main switch.
5.2. DAY / TIME PROGRAMMING
24
c
3
22:04
Press the (M) until the icon appears on the screen. Then press (OK)
to confirm. Next, press (OK) again for 3 seconds. The day of the week will
flash (1-Monday …. 7-Sunday) and we can adjust it pressing the (+) or (-)
buttons. We set the day pressing (OK) and do the same to adjust the hour
and minutes. Pressing (OK) to finish programming the time.
5.3. OPERATING MODES
STANDBY mode
Press the (M) button until the icon appears on the screen. When this icon appears on the
screen, the appliance is not heating, it is in standby mode.
COMFORT mode
24
c
3
22:04
Press the (M) button until the icon appears on the screen.
Then press (OK) to confirm. The desired temperature in the room will
start to flash and we can adjust it by pressing the (+) or (-) buttons. We
confirm by pressing (OK) and the actual room temperature will appear
on the screen. If the actual room temperature is below the desired tem-
perature, the wall heater will start heating, indicated on the screen with
the
icon. If on the other hand the actual room temperature is above
the desired temperature, the appliance will stay in standby mode.
NOTE: If it is a day room (dining room / living room) we recommend setting the thermostat
at +22/+23 ºC.