Determining and setting the
appropriate ozone output
As a rough guide, use about 10 mg of ozone per
hour for every 100 liters of salt water, or about
5 mg of ozone per hour for every 100 liters of
fresh water.
When first using the ozonizer, we recommend
slowly increasing the ozone output over
a timespan of about 14 days, so that the
aquarium may gradually adjust to the enhanced
water quality.
Operation with the Sander Redox Controller
For precise management of your setup’s ozone
requirement, we recommend using the ozonizer
in combination with a redox controller (
Sander
redox potential detector and controller, part
number 7.1C
). This device automatically turns
the ozonizer on or off, depending on a set value
for the redox potential.
To connect the redox controller, remove the
dummy plug from the 4-pin socket
(8)
on the
ozonizer, and replace it with the single plug on
the supplied redox controller adapter cable.
Then connect the two plugs on the other end of
the cable with the redox controller.
The actual value for the redox potential, as well
as the controller state, are displayed on the
redox controller’s top panel.
For further instructions, please refer to the
redox controller’s user guide.
Ozonizer
XT2000
Sander
Redox Controller
Power
supply
Содержание XT2000
Страница 1: ...Ozonizer XT2000 User Guide EN...
