ENSTROM 480B RFM SUPPLEMENT
2-1
FAA Approved: Dec 3/14
Rev. 1
Report No. 28-AC-049
Nov 12/14
CHAPTER 2. NORMAL PROCEDURES
2-1. Starting Engine
Add the following steps to para. 2-19, “Starting Engine”,
after switching the avionics master switch ON:
1. The SN3500 will perform a power-on self-test and
display an introduction screen.
a. Verify the software version as listed in Table 1-1.
b. Verify the compass card display appears a few
seconds after the introduction screen.
2. Keep aircraft stationary during the AHRS
initialization period.
CAUTION
The aircraft should be stationary during the
AHRS initialization period. The initialization
may take up to three minutes after power is
applied.
2-2. Engine Runup
Add the following Check to step 11 of para. 2-20, “Engine
Runup”:
1. Check the gyro flag (
GYRO INVALID) is removed
from the SN3500 heading display and the compass rose is
white after the initialization period.
2. Check the reversionary mode capability (if equipped)
by activating the
ATTD IND switch. Ensure the display
information compares identically with the primary attitude
indicator. Press the
ATTD IND switch again to return to
HSI mode.
This electronic document is not linked to a subscription for revision control or distribution. Refer to the Optional Equipment
Supplement Publications Status link under the Technical Support Page of the Enstrom Helicopter website for the current revision
level of this Rotorcraft Flight Manual Supplement.
UNCONTROLLED COPY WHEN DOWNLOADED OR PRINTED
