S&C BankGuard PLUS, Инструкции по установке

Страница: 27 / 50

27 1011-530
Table 2. Setpoints Available from Faceplate Shortcut Buttons.
LCD Setup Mode
Once you are in setup mode, you can change setpoint values from the faceplate. Table
3 shows the names and order of setpoints and real-time data displayed on the LCD. To
move to the next item on the list, press the
NEXT button. To move to the previous item
on the list, press the PREV button.
To change a setpoint value, press ENTER when it is displayed. The value shown on the
LCD will blink to indicate that you can change it. Use the + and – buttons to enter the
desired value. Press ENTER to accept the new value or ESC to cancel.
NOTE: If you press ESC when a value is not blinking, the LCD returns to display mode
and reads
[N-G Voltage]
.
UNBALANCE
COMPENSATION Button LOCKOUT LEVEL Button ALARM LEVEL Button
Unbalance
compensation value
in use “Lockout Level”
setpoint “Alarm Level” setpoint
A new calculated
unbalance
compensation value “Lockout Time Delay”
setpoint “Alarm Time Delay”
setpoint
Comparison between
the “Lockout Level”
setpoint and the
neutral-to-
ground/unbalance
voltage Comparison between
the “Alarm Level”
setpoint and the
neutral-to-
ground/unbalance
voltage
Comparison between
the “Gross Overvoltage
Level” setpoint and the
neutral-to-
ground/unbalance
voltage Comparison between
the “Gross Overvoltage
Level” setpoint and the
neutral-to-
ground/unbalance
voltage