6
How not to store a reading
Press the ON/OFF button
1
while the reading is being displayed.
Keep the button pressed until «
M
»
AL
is
ng and then release it.
by pressing the M-button.
4. Appearance of the Heart Arrhythmia Indicator for
early Detection
This symbol
AN
indicates that certain pulse irregularities were
detected during the measurement. In this case, the result may
deviate from your
5. Always ensure that the
is positioned correctly, as shown
in the pictures illustrated on the short instruction card.
•
Fit the
closely, but not too tight.
•
Make sure that the
is 2 cm (0.75 inch) above your elbow
with the tube on the inside of your arm.
•
Support your arm so it is relaxed.
•
Ensure that the
is at the same height as your heart.
6. Press the ON/OFF button
1
to start the measurement.
7. The cu will now pump up automatically. Relax, do not move
and do not tense your arm muscles until the measurement
result is displayed. Breathe normally and do not talk.
8. When the correct pressure is reached, the pumping stops
and the pressure falls gradually. If the required pressure
was not reached, the instrument will automatically
pump
some more air into the
9. During the measurement, the heart symbol
AT
in
the display and a beep sounds every time a heartbeat is
detected.
10.The result, comprising the systolic
7
and the diastolic
8
blood pressure and the pulse
9
is displayed and longer beep
is heard. Note also the explanations on further displays in this
booklet.
11.When the measurement has
remove the
12.Switch
the instrument. (The monitor does switch
auto-
matically after approx. 1 min.).
You can stop the measurement at any time by pressing
the ON/OFF button (e.g. if you feel uneasy or an
unpleasant pressure sensation).
