background image

- 5 -

- 4 -

1. Install faucet

I N S T A L L   F A U C E T

(Caution !)

 

Excessive bending will cause 
leaking and damage to the pipes.

Nut

Compression Ring

Tighten

Temporary
Tighten

1

2

3

9

8

10

11

12

Either ordinary flow or shower flow can be used.

Ordinary flow

45 degree each

The spout head is twistable in 45 degree each.

Shower flow

Caution!

:

* Don’t loosen the nut while water is running. This may cause to injure 
   properties, due to the water leakage.
* Don’t twiste excessively.
  The twisting angle of the spout head should be less than 45 degree each.

PRIOR TO INSTALLATION

Prior to installing new faucet, install the items listed below: 

* Kitchen sink
* Drain Line

Important !
* All plumbing is to be installed in accordance with applicable codes and 
   regulations.
* Flush all water lines prior to making connection.

4. Work testing

Please go to "Flushing Instruction" section before starting to use faucet.

Be sure that mounting space is clean and dry.
The front side of the spout should face you. Then, make tightening the lock nut(12).
(counterclockwise) Please don’t forget to put a seat packing(9), rubber packing
(10), and metal washer(11), between faucet body(8) and lock nut(12).  

2. Bending copper pipes

Please bend the copper pipes refer to the instruction.
Excessive bending may cause water leakage and damage to the pipes.

3. Connection

Connect copper supply pipes(26) to the existing hot and cold stop valves(not supplied).
(Please don’t forget to put the compression ring(not supplied) between the nut 
and stop valve.)
Make tightening the nut of stop valves(not suuplied).

Hot Water
Pipe

Hot Water
Pipe

Cold Water
Pipe

Cold Water
Pipe

26

26

26

26

Содержание K877-BW








Отзывы: