Installation and Operation Manual
57
5-2 Connections
The GPS chart plotter has connectors that are used to connect to the power supply, GPS
antenna and to NMEA devices such as VHF’s AIS receivers, digital instruments and autopilots.
5-3 Power / Data Cable
Power
• Connect each equipment as the below picture for Power
.
5-4 GPS Antenna
5-4-1 External Antenna
It is available to connect to an external
GPS Antenna with BNC type of Connector.
Install an External Antenna
If an external antenna is required, install the
antenna and fit the antenna cable back to
the display unit. Follow the instructions in the
manual supplied with the antenna. Fit an
optional extension cable if required.
During setup, configure the data for the
chosen antenna.
Power / Data Cable
FUSE 2A
PIN No : 1
PIN No : 5
Installation and Operation Manual
58
5-4-2 The Antenna by using NMEA
Antenna by using NMEA
The chart plotter can receive the GPS data
from the compatible device (NMEA). The
chart plotter can connect several devices to
an external GPS.
• An opt
ional differential beacon DGPS
antenna to give enhanced accuracy within
range of land based differential beacons in
areas where WAAS or EGNOS are not
available. Such a DGPS antenna has both a
GPS receiver and a beacon receiver, and it
automatically applies the beacon correction
to the GPS position.
To set the DGPS options(None or
WAAS/EGNOS):
Connect the GPS directly to the input. Set the
option. The new setting will be displayed if it
was successfully applied.
Note:
The chart plotter can apply the WAAS and
EGNOS DGPS corrections to any GPS
antenna.
For more information, contact Samyung ENC.
5-5 Sonar
Sonar
• Connect each equipment as the below picture for
Sonar power.
Sonar