Samsung WF457ARGSWR/AA, Руководство пользователя

Страница: 60 / 228

60 _ Troubleshooting
Troubleshooting
PROBLEM SOLUTION
Fills with the wrong
temperature water. • Turn both faucets on fully.
• Make sure the temperature selection is correct.
• Make sure the hoses are connected to the correct faucets.
Flush water lines.
• Check the water heater. It should be set to deliver a minimum 120° F
(49° C) hot water at the tap. Also check the water heater capacity and
recovery rate.
• Disconnect the hoses and clean the screens. The hose fi lter screens may
be plugged.
• As your washer is fi lling, the water temperature may change as the
automatic temperature control feature checks the incoming water
temperature. This is normal.
• While your washer is fi lling, you may notice just hot or just cold water
going through the dispenser when the cold or warm wash temperature is
selected. This is a normal function of the automatic temperature control
feature as your washer determines the temperature of the water.
Door is locked or will not
open. • Press the Start/Pause Button to stop your washer.
• Your washer door will remain locked during the heating portion of the
Sanitize Cycle
• It may take a few moments for the door lock mechanism to disengage.
Does not drain and/or spin. • Check the fuse or reset the circuit breaker.
• Straighten the drain hoses. Eliminate bent hoses. If there is a drain
restriction, contact the customer service center.
• Close the door and press the Start/Pause Button. For your safety, your
washer will not tumble or spin unless the door is closed.
• Make sure the debris fi lter is not clogged.
Load is too wet at the end
of the cycle. • Use the High or Extra High spin speed.
• Use high effi ciency detergent to reduce over–sudsing.
• The load is too small. Very small loads (one or two items) may become
unbalanced and not spin out completely.
Leaks water. • Make sure the door is fi rmly closed.
• Make sure all hose connections are tight.
• Make sure the end of the drain hose is correctly inserted and secured to
the drainage system.
• Avoid overloading.
• Use high effi ciency detergent to prevent over–sudsing.
Has excessive suds. • Use high effi ciency detergent to prevent over-sudsing.
• Reduce the detergent amount for soft water, small or lightly soiled loads.
• Non-HE detergent is NOT recommended.
Has an odor. • Excessive suds collect in nooks and crannies and can cause foul odors.
• Run cleansing cycles to sanitize the machine periodically. (Silver Care or
Sanitize Cycle or Pure Cycle)
• Clean the door seal (Diaphragm).
• Dry the interior of your washer after the total cycle has fi nished.
WF457ARG-03153A-04_EN.indd 60 WF457ARG-03153A-04_EN.indd 60 2012-08-31 12:30:35 2012-08-31 12:30:35