Samsung WF361BVBEWR, Руководство по обучению

Страница: 48 / 73

Problem What To Do
Wet Clothes
• Unbalance due to not enough load. Put additional load.
• Due to excessive suds by using general detergent. Use HE (High-Efficiency) or
reduce its quantity.
• Low Spin Speed or Drain Only was selected.
• Go to “ Will Not Spin”.
Will Not Lock
• Door is not aligned or closed properly.
• Perform Quick Test Mode. Check Door Lock. Check the output voltage of Door
Lock Coil.If it reads 120V, change Door Lock Switch, and if not, change PCB.
(Refer to PCB Connector Check.)
• Read Lock Switch and PCB (CN3). (Refer to PCB Connector Check.)
• Try Door Lock and check for 120V to Door Lock Connector. If 120V present,
change Main Control Board and if not, change Door Lock switch.
Will Not Unlock
• Check if the door is being pushed out, which may keep it from unlocking.
• Door locks itself when the water level is too high. Opening door will result in
water draining from door opening.
• Check the following with Board Input Test Mode. Water Level (frequency): Over
23.80 KHz. If so, refer to “Will Not Drain”. Temperature (Inside Drum): Higher

than 60ºC/140ºF. If so, wait until it drops. When everything is normal, check

PCB connectors and Door Lock Switch.
• Drain manually after removing the plastic drain hose holder.
• Display shows “LO”. Turn off and on the unit. If “LO” keeps illuminating, check
PCB and Door Lock Switch.
• Read Lock Switch and PCB (CN2 & CN3). (Refer to PCB Connector Check.)
• Perform Quick Test Mode. Check Door Lock. Check the output voltage of Door
Lock Coil. If it reads 120V, change Door Lock Switch, and if not, change PCB.
(Refer to PCB Connector Check.)
5.SVC Information ( Troubleshooting)
48