28_
cleaning and maintaining your washer
PURE CYCLE
TM
(WF221*)
Pure Cycle is a self-cleaning cycle that removes mold that may occur inside the washing machine.
1.
Press the
Power
button.
2.
Press the
Pure Cycle
TM
button.
• You can only use the Delay Start
function.
3.
Press the
Start/Pause
button.
• If you press the
Start/Pause
button, Pure Cycle begins.
• The required time for the Pure Cycle is determined by the temperature of the supplied water.
In general, if hot water is supplied, the Pure Cycle will take approximately 2 hours.
• Using Pure Cycle, you can clean the drum without using a cleansing agent.
•
Never use Pure Cycle when laundry is in the washing machine. This may cause damage to
the laundry or a problem with the washing machine.
•
If you want to use drum cleansing agent, use only 1/10 of the amount of the drum
cleansing agent recommended by the cleansing agent manufacturer.
(When using a
powder-type cleansing agent , remove the liquid detergent compartment.)
The Pure Cycle Auto Alarm Function
•
If the “
Pure Cycle
” button is lit after a wash, it indicates
that tub (drum) cleaning is required. In this case, remove
the laundry from the washing machine, turn the power on,
and clean the drum by running Pure Cycle.
•
If you do not run Pure Cycle, the “
Pure Cycle
” indicator
turns off. However, the “
Pure Cycl
e” indicator will light
again after two washes. Not running Pure Cycle at this
point will not cause a problem with the washing machine.
•
Although generally, the Pure Cycle Auto Alarm appears
once a month or so, the frequency may differ depending
on the number of times the washing machine is used
cleaning and maintaining your
washer
CAUTION
WF221ANS-02832F_EN_v5_re.indd Sec7:28
WF221ANS-02832F_EN_v5_re.indd Sec7:28
2011-07-15
3:17:26
2011-07-15
3:17:26
