setting up your washer
_17
4.
Turn on the HOT and COLD water supply and check all
connections at the water valve and the faucet for leaks.
5.
Plug the power cord into a 3-prong, well grounded 120 volt
60 Hz approved electrical outlet protected by a 15-amp fuse
or comparable circuit breaker.
Your washer is grounded through the third prong of the
power cord when plugged into a three-prong grounded
receptacle.
6.
Slide your washer into position.
7.
Level your washer by turning the leveling legs in or out as
necessary by hand or by using the wrench included with your
washer.
When your washer is level, tighten the locking nuts using the
wrench or (-) flathead screwdriver.
Your washer must be leveled on all four sides. A carpenter’s
level should be used on all four corners of your washer. It’s
the best to recheck after the first dozen washes.
Avoid damage to the legs. Do not
move the washer unless the locking-
nuts are fastened to the bottom of the
washer.
01
S
ETTING UP YOUR W
ASHER
Cold printed
Hot printed
WF210AN-02832B_EN.indd 17
2010-03-19 ¿ÀÈÄ 4:21:50
