English - 20
setting up your washing
machine
Connecting the drain hose
The end of the drain hose can be positioned in three ways:
1.
Over the edge of a wash basin:
The drain hose must be placed at a height of between 60
and 90 cm. To keep the drain hose spout bent, use the supplied plastic hose guide. Secure
the guide to the wall with a hook or to the tap with a piece of string to prevent the drain hose
from moving.
2.
ln a sink drain pipe branch:
The drain pipe branch must be above the sink siphon so that
the end of the hose is at least 60 cm above the ground.
3.
ln a drain pipe:
We recommend using a 65 cm high vertical pipe; it must be no shorter than
60 cm and no longer than 90 cm.
STEP 5
Powering your washing machine
Plug the power cord into a wall sockets, an AC 220-240 V / 50 Hz approved electrical outlet
protected by a fuse or circuit breaker. (For more information on electrical and grounding
requirements, see page 14.)
Test run
Make sure that you install your washing machine correctly by running the
Rinse + Spin
cycle after the installation is complete.
STEP 6
Calibration Mode
Run calibration mode, when the washing machine is installed for the fi rst time (or you want to
calibrate it).
1.
Remove laundry or any contents in the machine and turn off the machine.
2.
When you press and hold on the “
Temp
” and “
Delay End
” button, press the “
Power
”
button.
3.
If the machine turns on, press the “
Start
” button. The calibration mode starts.
4.
The drum spins right and left side on several times. (The calibration mode will take about
minutes.)
5.
When the calibration fi nish, “
END
” message displays.
6.
If the door is unlooked, the machine turn off automatically.
Drain hose
Hose guide
60 ~ 90 cm
YUKON-03073P-04_EN.indd Sec4:20
YUKON-03073P-04_EN.indd Sec4:20
4/7/2016 11:31:28 PM
4/7/2016 11:31:28 PM
