English
27
Installation
STEP 5
Power on
Plug the power cord into an AC 120 V / 60 Hz / 12 AMP approved electrical outlet
protected by a 15-amp fuse or circuit breaker. Then, press
Power
to turn on the washer.
STEP 6
Run a test cycle
Run a test cycle as follows to check if your washer is properly installed.
1.
Load about 6 lb. of laundry into the tub.
2.
Press
Power
to turn on your washer.
3.
Turn the
Cycle Selector
to
RINSE+SPIN
.
4.
Press and hold
Start/Pause (Hold to Start)
to start the test cycle.
5.
The washer should not rock or vibrate excessively when water is supplied or when
washing and spinning, and should drain well during the spin cycle.
NOTE
•
If water leaks while water is being supplied or drained, check the water connections.
See “
Connect the water hose
” on page
22
.
•
If the washer rocks and vibrates excessively, level your washer again. See “
Level the
washer
” on page
25
.
Untitled-3 27
Untitled-3 27
2021-10-25 6:39:21
2021-10-25 6:39:21
Содержание WA52B7650A Series
Страница 1: ...Washer User manual WA52B7650A Untitled 3 1 Untitled 3 1 2021 10 25 6 38 59 2021 10 25 6 38 59 ...
Страница 67: ...Memo Untitled 3 67 Untitled 3 67 2021 10 25 6 39 31 2021 10 25 6 39 31 ...
Страница 69: ...Lave linge Manuel d utilisation WA52B7650A Untitled 2 1 Untitled 2 1 2021 10 26 11 29 59 2021 10 26 11 29 59 ...
Страница 135: ...Mémo Untitled 2 67 Untitled 2 67 2021 10 26 11 30 29 2021 10 26 11 30 29 ...