Samsung WA19J3000A Series, Руководство пользователя

Страница: 15 / 72

English - 15
Connecting the drain hose
The end of the drain hose can be positioned in three ways:
in a Wall standpipe or floor standpipe
The height of end of standpipe must be no lower than 39 in (99 cm) and no
higher than 96 in (245 cm).
If drain pipe are built into the wall with water valves (A), fasten the drain hose
to the water hose.
Make sure that the connection between the drain hose and the
standpipe is not airtight.
in a laundry tub
The height of the tub must be no lower than 39 in (99 cm) and no higher than
96 in (245 cm).
Assemble the supplied Hose guide at the end of the drain hose, and put the
hanger on laundry tub.
And fasten the drain hose to the leg of laundry tub.
Connect the hose guide (A) within 3~5 in (7.6~12.7 cm)* from the end of
the drain hose. If the drain hose is extended beyond the end of the hose
guide, mold or microorganisms could spread inside the washer.
The Drain Hose can be installed up to 96 in (245cm) above the floor, but
the draining capability can be reduced at this height. This can cause the
washer to have an odor because of water remaining in the drain system.
If the drain hose is installed below 39 in (99cm), water can drain during wash cycles due to
a siphon effect. If this occurs, it causes the Tap cold LED on the washer to flash.
step 3
Leveling your washer
See if the washer is level by checking the position of the tub:
1. Slide the washer into position.
2. Open the lid of the washer, and pour the water into the tub to
just below the pulsator level.
3. If the washer is level, the pulsator will be centered in the washer as
shown in the figure. If the pulsator is not centered, level your washer
by turning the front leveling feet clockwise or counterclockwise as
necessary.
Turn the front leveling feet clockwise to raise the washer, and
counterclockwise to lower the washer.
A
C
*
A
01 installing your washer
loosen lock
pulsator
adjustable legs
WA3000J_WA19J3000AW_DC68-03520V_EN.indd 15 2016/11/21 14:09:40