Install the drain hose in the
position of about 90~100cm
above the ground.
10
●
When a proper amount (one time does) of fabric
softener is stored in the softener inlet,it is
automatically put in at the last rinsing cycle.
●
Do not use detergent, bleach or starch into
the Softener Inlet.
●
Using too much softener may produce
unsatisfactory results.
●
Do not open the lid during the Spin Dry cycle.
If added too early, its effectiveness will decrease.
●
Do not leave the softener
into the Softener
Dispenser for a long time.
Because softner
became stiff.
CONNECTING THE DRAIN HOSE
After pressing the joint ring(a), insert the drain hose(b)
to drain direction.
(a)
(b)
Sisi belakang
70~80cm
Be sure to join tightly the drain
hose into the drain-outlet
on the side of the machine.
Be sure to join tightly the drain hose into
the drain-outlet on the back of the
machine.
Take out the cap-hose and
connect the outlet-hose.
IN CASE OF PUMP-DRAINED WASHER
cap-hose
outlet-hose
ASSEMBLING THE RAT PROTECTION PANEL
1.
Insert the sound
absorbing panel
to the assembling
hole on front side
to the end.
2
.If you have difficulty
inserting the panel
lift up the washer a
little and insert it
Tilt the washer a little and lift up the panel until it clicks,
finally fix the panel with screw to the base as shown
in the figure.
HOW TO ADD THE FABRIC SOFTENER
1
.Open the detergent box by pulling in the direction of the arrow as shown in the
figure and then put the powder detergent in the detergent box.
2
. Put in one-time amount of detergent evenly so the detergent may not brim over the box.
HOW TO PUT THE DETERGENT IN
Detergent Device
Put the detergent
in proportion to
water level
Softener Device
Softener
baseline
90~100cm
CAUTION :
If softener is stored over the above base line, it may flow down at any time.
Anti-rat cover
01174A-WA1265B0-gb 1904/1/11 6:46 AM Page 11
