58
ENGLISH
Troubleshooting Check
Checking
✤
If you run into any problem using the camcorder, use the following table to try and resolve the problem.
✤
If these instructions do not allow you to solve the problem, take a note of:
■
The model and serial number marked on the bottom of the camcorder.
■
Your warranty, if applicable.
✤
Then contact your nearest authorized service centre.
Symptom
Explanation/Solution
You cannot switch the camcorder on.
◆
Check the battery pack (see page 19)
or the AC power adapter. (see page 18)
Start/Stop does not operate while
◆
Check the POWER set it to CAMERA.
shooting.
◆
You have reached the end of the cassette.
◆
Check the record protection tab on the cassette. (see page 22)
The camcorder goes off automatically.
◆
You have left the camcorder set to STANDBY
for more than 5 minutes without using it.(see page 24)
◆
The battery pack is fully used up. (see page 21)
The battery pack is quickly exhausted.
◆
The atmospheric temperature is too low. (see page 21)
◆
The battery pack has not been charged fully.(see page 19)
◆
The battery pack is completely dead, and cannot be recharged.
Use another battery pack.
You cannot eject the cassette from
◆
The battery pack is fully discharged.
the compartment.
◆
A mechanical fault may have occurred. (see page 57)
The DATE/TIME indicator flashes
◆
The lithium battery is not installed or is fully used up. (see page 17)
more than 2 times when you set the
camcorder to CAMERA.
The playback picture is in poor quality.
◆
The video heads might be dirty. (see page 55)
You can do nothing
◆
A mechanical fault may have occurred. (see page 57)
with the camcorder.
00761D VP-W90 UK (44-64) 5/6/04 9:59 AM Page 58