E-
12
Drain Hose
Drilling a Hole in the Wall
◆
Drill a hole of 60mm in diameter to the outside.
◆
The drilling should be done at a distance of less than
200mm from the floor facing the indoor unit.
◆
Extend the drain hose to the drain hose connected to
the drain pan, and fix it with the tape or a cable-tie to
prevent separation. Then make a covering of it so
that water cannot flow outwardly.
CAUTION
1. As the draining is of natural drain type, make the drain hose direct
downward.
2. If there is any foreign substance in the drain plate, it may clog the
drain pipe. Therefore, be sure to remove the foreign substance
inside after installation.
3. After completion of installation, be sure to pour water into the drain
pan, and then check the draining condition.
(There is no problem in draining when the draining is completed
within 20 seconds.)
Ø 60mm
Less than
200mm
Foamed Polyethylene
Insulator
Vinyl Chloride(Inner diameter ø18mm,
Outer diameter ø23mm)
Piping Material
INSTALLATION METHOD
Drain hose
Drain pan
Indoor and outdoor
connection
Insulation
Band
