Samsung UH026EAV Series, Руководство по установке

Страница: 14 / 58

Drain pipe and Drain Hose Installation (Continued)
Prepare a little water about 5 liter.
Open the cover of water supply intake by turning and pulling the cover.
(Only for
✴✴
035
✴✴
)
1
Pour water into the the indoor unit as shown in figure. 2
Confirm that the water flows out through the drain hose. 3
Testing the drainage
E-
14
Water supply intake
If you do not pour water inside the water supply intake,
water may spill from the indoor unit.
N N
N N
o o
o o
tt
tt
e e
e e
Reassemble the cover of water supply intake.
(Only for
✴✴
035
✴✴
)
4
✴✴
035
✴✴
✴✴
052/070
✴✴
C C
C C
A A
A A
U U
U U
T T
T T
II
II
O O
O O
N N
N N
When not installing the drain pump
Do not give the hose upward gradient after
the connection port.
This will cause water to flow backwards when
the unit is stopped, resulting in water leaks.
Do not apply force to the piping on the unit side
when connecting the drain hose. The hose should
not be allowed to hang loose from its connection to
the unit. Fasten the hose to a wall, frame or other
support as close to the unit as possible.
Upward gradient
Support pieces
Ceiling
Ceiling
20mm or more
550mm or less
Ceiling
Flexible hose
1/100 or more
When installing the drain pump(
✴✴
035
✴✴
)
When installing a flexible hose, the difference of
pivot of a drain hose port and a drain hose must
be within 20mm. If the difference of each pivot is
more than 20mm, or a flexible hose is bent
steeply, a flexible hose may leak.
75cm or less
Ceiling
When installing the drain pump(
✴✴
052/070
✴✴
)
If it is necessary to increase the height of the
drain hose somewhat, the portion directly after
75cm. If it is raised higher than 75cm, there can
be water leaks.
EH035EAV_IM_E_25807 3/24/06 7:21 PM Page 14