Samsung UE C7 00W Series, Руководство по обслуживанию

Страница: 3 / 121

1-1
1. Precautions
1. Precautions
1-1. Safety Precautions
Follow these safety, servicing and ESD precautions to prevent damage and to protect against potential hazards such as
electrical shock.
1-1-1. Warnings
For continued safety, do not attempt to modify the circuit board. 1.
Disconnect the AC power and DC power jack before servicing. 2.
1-1-2. Servicing the LED TV
When servicing the LED TV, Disconnect the AC line cord from the AC outlet. 1.
It is essential that service technicians have an accurate voltage meter available at all times. 2.
Check the calibration of this meter periodically.
1-1-3. Fire and Shock Hazard
Before returning the LED TV to the user, perform the following safety checks:
Inspect each lead dress to make certain that the leads are not pinched or that hardware is not lodged between the 1.
chassis and other metal parts in the LED TV.
Inspect all protective devices such as nonmetallic control knobs, insulating materials, cabinet backs, adjustment and 2.
compartment covers or shields, isolation resistorcapacitor networks, mechanical insulators, etc.
Leakage Current Hot Check (Figure 1-1): 3.
WARNING : Do not use an isolation transformer during this test.
Use a leakage current tester or a metering system that complies with American National Standards Institute (ANSI
C101.1, Leakage Current for Appliances), and Underwriters Laboratories (UL Publication UL1410, 59.7).
With the unit completely reassembled, plug the AC line cord directly into a 120V AC outlet. With the unit’s AC switch 4.
¿UVWLQWKH21SRVLWLRQDQGWKHQ2))PHDVXUHWKHFXUUHQWEHWZHHQDNQRZQHDUWKJURXQGPHWDOZDWHUSLSHFRQGXLW
etc.) and all exposed metal parts, including: metal cabinets, screwheads and control shafts.
The current measured should not exceed 0.5 milliamp.
Reverse the power-plug prongs in the AC outlet and repeat the test.
1-1-4. Product Safety Notices
Some electrical and mechanical parts have special safetyrelated characteristics which are often not evident from visual
inspection. The protection they give may not be obtained by replacing them with components rated for higher voltage,
ZDWWDJHHWF3DUWVWKDWKDYHVSHFLDOVDIHW\FKDUDFWHULVWLFVDUHLGHQWL¿HGE\ on schematics and parts lists. A substitute
replacement that does not have the same safety characteristics as the recommended replacement part might create
VKRFN¿UHDQGRURWKHUKD]DUGV3URGXFWVDIHW\LVXQGHUUHYLHZFRQWLQXRXVO\DQGQHZLQVWUXFWLRQVDUHLVVXHGZKHQHYHU
appropriate.
DEVICE
UNDER
TEST
5($',1*6+28/'
127%($%29(P$
LEAKAGE
CURRENT
TESTER
TEST ALL
(;326('0(7$/
SURFACES
:,5(&25'
$/627(67:,7+
PLUG REVERSED
(USING AC ADAPTER
PLUG AS REQUIRED)
EARTH
*5281'
Figure 1-1. Leakage Current Test Circuit