menu setting
30
_
menu setting
Joystick’s Serial Command Transfer Cycle
Select a PTZ serial command transfer cycle for using the joystick.
Shortening the transfer cycle increases the response speed of the camera.
J
Shortening the joystick’s serial command transfer cycle may cause certain camera models to not process commands
properly.
To prevent and resolve such malfunctions, extend the transfer cycle.
Password
You can set the controller password.
Enter a new password.
M
The default password is “
4321
”.
J
The default password can be exposed to a hacking thread so it is recommended to change the password after
installing the product.
Note that the security and other related issues caused by the unchanged password shall be responsible for the user.
Factory Set
Resets the controller’s current settings to the factory release default values
and optimizes the joystick calibration.
[
M A I N S E T U P
]
7. JOY SPD : 100MS
[
M A I N S E T U P ]
8. PASSWORD : ****
[
M A I N S E T U P ]
9. FACTORY SET
Содержание SPC-2010
