- 5 -
INSTALLATION
The Microwave Oven is supported by a special
bracket assembly (mounting system) supplied
with the oven. The bracket assembly must be
mounted to the wall with toggle bolts through
the wall, and a lag screw into a wall stud.
After the bracket assembly is installed, the unit
can be slid over the two rails of the bracket
assembly. Two bolts are run down through
the cabinet bottom and into the oven case to
pull the oven up against the cabinet bottom.
NOTE
: For easier removal and personal safety
it is recommended that two people
remove this product.
CAUTION!
The mounting surface must be capable of
supporting the cabinet load, in addition to the
64 pound product, plus additional loads of up
to 50 pounds or a
total weight of 114 pounds.
This product cannot be installed to cabinet
arrangements such as an island or peninsula.
It must be mounted to both a top cabinet and
wall.
VENT BLOWER
The vent or exhaust blower is located at the top
of the oven. It is shipped for vertical exhaust but
can be changed to rear exhaust or recirculating
(See installation instrustions on how to change
and/or blower section on how to remove).
COOKTOP LIGHTS
Two 40-watt screw base incandescent bulbs are
located on the bottom between the four grease
filters. The bulbs are user replaceable by removing
one screw and lowering access cover. The bulbs
could be difficult to remove when replaced for the
first time. a silicone glue is used to secure them
during shipping.
OVEN LIGHT
A 40-watt screw base incandescent bulb is located
in the top of the oven cavity at the front.
It is user replaceable by removing the top grill
(2 screws. On the front of outer case.). The bulb
is then accessible by removing a metal cover (1 screw).
Mounting Plate
