- 17 -
5-10 SENSOR
The Sensor Cooking Function uses a special gas
sensor which detects both humidity(steam) and
hydrocarbons(food odors) during the cooking
process. Before conducting either of the sensor
tests below, ensure the unit is plugged into a will
outlet for at least 5 minutes. If already plugged
in, proceed. The sensor is a plug-in device
located in the vent area at the top left hand
corner of the cavity behind the grille.
To Service :
1. Disconnect power and remove grille.
2. Separate retainer from receptacle and
unplug sensor.
SENSOR COOKING TEST
1. Place 1/3 cup tap water in oven.
2. Touch potato , the oven starts immediately.
3. Control Beeps and Shuts off.
4. Touch Pause/Cancel .
1) Test
OK
- Normal
2) Test
Fails
- Check Sensor. See Sensor Test Below.
SENSOR TEST (QUICK TEST)
1. With 2 fingers touch and hold the following pads at the same time :
Auto Defrost
and Sensor Reheat
2. Observe diagnostic number in display (Numbers approximate).
●
15-185
(Normal-verify with "detection test" )
●
213
or Higher (Sensor failed to open, sensor
unplugged, wiring or smart board.)
●
Less then 6 (shorted sensor, or smart board).
NOTE :
Only heater terminals ( H ; Black and Red leads) can be checked with ohmmeter(30
Ω
).
CAUTION : DO NOT ATTEMPT TO CHECK SENSOR TERMINALS (White and Orange leads).
※
CAN DAMAGE SENSOR.
VENT MOTOR
GAS SENSOR
