Samsung SMH1816B, Руководство по установке

Страница: 9 / 40

8
Step-by-step installation guide
9
Step-by-step installation guide
C. DETERmINING WALL PLATE LOCATION UNDER YOUR CABINET
CL
CL
CL
Plate position – beneath recessed bottom
cabinet with front overhang.
30˝ to Cooktop
Draw a horizontal line to
mark how far the inside
of the front overhang
descends below the
cabinet.
Your cabinets may have decorative trim that interferes
with the microwave installation. Remove the decorative
trim to install the microwave properly and to make it
level.
THE mICROWAVE mUST BE LEVEL.
Use a level to make sure the cabinet bottom is level.
Draw a vertical line on the wall at the center of the 30˝
wide space. Draw a second, horizontal line on the wall
below the cabinet to mark how far the inside of the
front overhang descends below the cabinet. Tape the
Rear Wall Template onto the wall so that the top of the
template touches the bottom of the horizontal line and
the centerline on the template lines up with the vertical
line.
1. PLACEmENT OF THE mOUNTING PLATE
B. FINDING THE WALL STUDS
1 . Find the studs using one of the following
methods:
A. Stud finder–a magnetic device which locates
nails.
OR
B. Use a hammer to tap lightly across the
mounting surface to find a solid sound. This
will indicate a stud location.
2 . After locating the stud(s), find the stud’s center
by probing the wall with a small nail to find the
edges of the stud. Then, place a mark halfway
between the edges. The center of any adjacent
studs should be 16˝ or 24˝ from this mark.
3 . Draw a line down the center of the studs.
THE mICROWAVE mUST BE CONNECTED TO
AT LEAST ONE WALL STUD.
Draw a vertical line on the
wall at the center of the
30˝ wide space. Tape the
Rear Wall Template onto
the wall so that the top
of the template touches
the bottom of the cabinet
and the centerline on the
template lines up with the
line you drew on the wall.
Plate position – beneath framed recessed
cabinet bottom.
30˝ to Cooktop
Draw a vertical line on the wall at the center of the 30˝
wide space. Tape the Rear Wall Template onto the wall
so that the top of the template touches the bottom of
the cabinet frame and the centerline on the template
lines up with the line you drew on the wall.
Plate position – beneath flat bottom cabinet.
At least 30˝
16 ½˝
SMH1816_XAC_DE68-03943B-01_EN_120725.indd 9 2012-07-25 �� 7:50:48