Samsung SMH1816B, Руководство по установке

Страница: 14 / 40

14
Step-by-step installation guide
15
Step-by-step installation guide
C. OUTSIDE BACK EXHAUST (HORIzONTAL DUCT)
C1. ADAPTING THE mICROWAVE
BLOWER FOR OUTSIDE BACK
EXHAUST
1 . Remove and save the screws that hold the
Blower Plate to the microwave.
2 . Lift up the
Blower plate.
Screw
Blower Motor
Back of microwave
Blower Plate Screw
3 . Carefully pull out the blower unit. The wires will
extend far enough to allow you to adjust the
blower unit.
BEFORE: Fan Blade
Openings Facing Forward
End B
End A
CAUTION: To avoid breaking or cracking the blower
blade, do not touch the blade. Hold the outer case
of the blower when you pull it out or put it back in
place.
4 . Remove Parts “A” with tin snips or pliers.
Parts “A”
5 . Rotate the blower unit counterclockwise 180 °.
Before Rotation After Rotation
Back of microwave
Back of microwave
6 . Place the blower unit back into the opening.
AFTER: Fan Blade Openings
Facing Back
End B
End A
CAUTION: Do not pull or stretch the blower unit
wiring. make sure the wires are not pinched.
NOTE: The blower unit exhaust openings
should match exhaust openings on the rear of
microwave oven.
7 . Close the Blower Plate and attach the exhaust
adaptor to the rear of the oven by sliding it into
the guides at the back top center of the oven.
Push in securely until it is in the lower locking
tabs. Take care to ensure that the damper hinge
is installed so that it is at the top and that the
damper swings freely.
Locking Tabs
Adaptor
Guide
Back of
Microwave
Guide
From Blower motor screw
(after attached the exhaust adaptor)
INSTALLATION OVERVIEW
A . Prepare Rear Wall (horizontal duct only)
B . Attach Mounting Plate to Wall
C . Prepare Top Cabinet
D . Mount the Microwave Oven
E . Connecting Ductwork (vertical duct only)
A. PREPARING THE REAR
WALL FOR OUTSIDE BACK
EXHAUST
You need to cut an opening in the rear wall for
outside exhaust.
• Read the instructions for outside back exhaust
on the REAR WALL TEMPLATE.
• Tape the REAR WALL TEMPLATE to the rear
wall.
• Cut the opening, following the instructions on the
REAR WALL TEMPLATE.
CAUTION: Do not cut an opening in the rear wall if
you are installing the microwave with vertical duct or
non-vented ductless ventilation.
3. INSTALLATION
SMH1816_XAC_DE68-03943B-01_EN_120725.indd 14 2012-07-25 �� 7:50:51